What is Your Real Output?


Reading time ( words)

How should you define your output? Highest area productivity, lab speed, actual speed, optimum speed, IPC speed, or maximum speed? And is it speed or throughput we should be looking at? Neither is clearly defined, and we all have our rules of thumb (e.g., actual speed is 60% of IPC speed, which is 60% of maximum speed).

Currently, there is only one standard representing a fair comparison between pick-and place equipment: IPC-9850. It measures equipment speed (providing that components are placed within the specified accuracy of the equipment itself). IPC established IPC-9850 in 2002, defining the measurement procedures for specifying, evaluating and verifying surface mount placement equipment. With machine manufacturers producing a wide range of accuracies and outputs, it details how measurements must be made consistently, and is therefore the only real way to compare them. It has become a basic industry reference, but unfortunately doesn’t tell the whole story. Several pick-and-place machine manufacturers, for example, currently claim the industry’s fastest placement speeds on the basis of the IPC reference speed.

One key difference lies between the IPC-9850 speed and the actual speed you will reach in a particular application. And that is where IPC-9850 falls short.

For this reason, IPC published an updated version in January 2012: IPC-9850A. Since the release of this update, it has been adopted by…practically nobody. Admittedly, the new standard is far from perfect, as applications are usually still more complex than even it allows for. It is a step closer to the truth, though. Why have so few adopted it? Why do most manufacturers avoid publishing the results? It seems that this minor change in specification degrades output results so drastically that it is commercially too sensitive.

IPC-9850 and IPC-9850A: The Differences

IPC-9850 speeds are measured by placing a simple matrix of components (for example 80 SOIC-16s or 400 identical 0603 capacitors) on a 200 x 200 mm substrate. However, the standard says nothing about the electrical value of these 400 capacitors, for example. That allows sequential placement machines to use gang pick (simultaneous pick by multiple placement heads) using an optimized placement path. Gang pick, however, artificially inflates the performance figure since it can virtually never be used in an actual customer application. You just don’t get many circuits incorporating hundreds of identical 27-nF capacitors on a board in a small matrix in a 200 x 200 mm area.

Read the full column here.


Editor's Note: This column originally appeared in the March 2014 issue of SMT Magazine.

Share


Suggested Items

SMTAI 2018 Closes on a High Note

10/18/2018 | Barry Matties, I-Connect007
SMTA International 2018, which took place in Rosemont, Illinois is now in the history books. This multi-day event, held October 14-18, at the Donald E. Stephens Convention Center, was packed with keynotes, conferences, lively discussions, committee meetings and a two-day exhibition.

IoT: Driving Change in Manufacturing

10/15/2018 | Stephen Las Marias, I-Connect007
In the manufacturing world, the Internet of Things (IoT) can be seen as an element of Industry 4.0. The idea behind it is that factories would evolve to become smarter, to become a lot more flexible—to be able to make the products that customers want, basically at any time that they need.

Mark Curtin on Large-Board Stencil Printing and Metal Squeegees

09/24/2018 | Stephen Las Marias, I-Connect007
Transition Automation Inc. recently developed a large-area benchtop stencil printer targeted for high-mix low- or medium-volume production. In an interview with I-Connect007, Mark Curtin talks about the new system, and why metal squeegees are the way to go when it comes to solder paste printing.



Copyright © 2018 I-Connect007. All rights reserved.