Matched Length Does Not Always Equal Matched Delay


Reading time ( words)

In previous columns, I have discussed matched length routing and how matched length does not necessarily mean matched delay. But, all design rules, specified by chip manufacturers regarding high-speed routing, specify matched length--not matched delay. In this month’s column we’ll take a look at the actual differences between the two.

Typically, more than one layer change is required when routing traces to matched length. Figure 1 illustrates the DDR2 address bus routing I did in Altium Designer, my preferred layout tool. In this case, each address signal has four layer changes. The red and green traces are the top and bottom layers--which should be kept as short as possible--and the yellow and orange traces are inner layers embedded between the planes. This was a particularly difficult route as there were two DDR2 memory chips placed on both the top and bottom sides of the board, so each address signal had to go to four different chips and still maintain the correct delay.

 Olney_Delay.jpg

Figure 1: Matched delay T-section DDR2 address routing in Altium Designer.

The longest routes should be placed on the inner layers as this reduces electromagnetic radiation. With all other factors being equal, generally, a trace routed on the inner stripline layer exhibits 4-10 dB less noise than a trace routed on the outer microstrip  layer. Also, please note that there are more high harmonics on the top layer routing. The high-frequency components radiate more readily because their shorter wavelengths are comparable to trace lengths, which act as antennas. Consequently, although the amplitude of the harmonic frequency components decreases as the frequency increases, the radiated frequency varies depending on the trace’s characteristics.

Read the full column here.


Editor's Note: This column originally appeared in the March 2014 issue of The PCB Design Magazine.

Share

Print


Suggested Items

Real Time with… AltiumLive 2020: Vince Mazur Previews New Design Rule Features

11/03/2020 | I-Connect007 Editorial Team
Altium Technical Marketing Manager Vince Mazur discusses his presentation at the recent AltiumLive, which focused on updates to Altium Designer's approach to creating design rules and constraints. Vince explains that these features will be more intuitive for the user, and the update, which is currently in beta, will be released in the future. The company is shifting from “rule-centric” design rules features to capabilities that are more “design-centric,” with applicable rules for each object available at one click.

Real Time with… AltiumLive Europe: 21st-Century Tools Keynote

10/22/2020 | Pete Starkey, I-Connect007
Good morning, Europe!” Altium VP of Marketing Lawrence Romine said as he introduced the European edition of Altium’s PCB design conference—established as an annual must-attend event, but for 2020 presented in a virtual format. Pete Starkey brings you the details from AltiumLive Europe's opening keynote on 21st-century tools and what's coming in 2021.

I-Connect007 Editor's Choice: Five Must-Reads for the Week

10/09/2020 | Andy Shaughnessy, Design007 Magazine
It’s showtime! This past week, we saw quite a bit of news about virtual trade shows. It’s great to see show managers pivot from live, in-person events to virtual shows with only a few months to make it all happen. How would you like to be a show manager today?



Copyright © 2020 I-Connect007. All rights reserved.