How to Streamline PCB Thermal Design


Reading time ( words)

Thermal issues with a PCB design are mostly determined during the component selection and layout phases. After this point, only remedial actions are possible if components are found to run too hot. Addressing thermal issues early in PCB design, starting at the system or enclosure level to understand the flow environment critical for air-cooled electronics, can streamline the process. Assumptions about the airflow uniformity in early design that subsequently prove unachievable can have a disastrous effect on the commercial viability of the product and meeting the market window.

Begin Before Placement and Layout

Substantial work can be done well before layout is completed within the electrical design flow. A simple representation of the enclosure can provide information about the air flow profile over the board. Start by smearing the total board power over the total board surface, which will provide a temperature map that will show any hot regions that are caused by a badly distributed air flow. Treat the board as a block with an isotropic conductivity of between 5 W/mK and 10 W/mK to optimize enclosure-level air flow ahead of the PCB design.

Components inject heat locally into the board so the heat flux density into the board below a component will be higher than the average for the board. As a result, the local board temperature will be higher than that predicted in the simulation. Refine the model before using the board temperature to estimate component temperatures. If the board temperature at any point is close to the maximum component case temperature, this limit will be exceeded once the component heat sources are represented discretely.

Guesstimate Component Power

At this stage, make a best-guess estimate of the individual power budgets for the main heat dissipating components that will be used in the design and the approximate size of those packages. This will enable describing them as footprint heat sources in the simulation, smearing the remainder of heat uniformly over the board surface.

Before Selecting the Package, Use 3D Component Models

Include some form of 3D component model in the simulation before the component selection is finalized. By feeding the thermal results back before this milestone is reached, the thermal performance will more likely be considered in the package selection criteria. Some ICs are available in more than one package style, and not all package styles perform equally well from a thermal point of view. The need for a heatsink later may be eliminated by appropriate package selection.

Component temperature, either in the form of a case temperature or junction temperature depending on how the manufacturer has specified the component, is the key measure used to indicate whether the design is thermally acceptable.

Read The Full Article Here

Editor's Note: This article originally appeared in the March issue of SMT Magazine.

Share

Print


Suggested Items

The Convergence: IPC Merging CFX With IPC-2581

09/16/2019 | Andy Shaughnessy, I-Connect007
Gary Carter of XPLM and Michael Ford of Aegis Software are heading a group tasked with combining the IPC-2581 standard, now referred to as Digital Product Model Exchange (DPMX), with IPC’s Connected Factory Exchange (CFX). In this interview, they discuss the benefits that can be expected when these standards are fully merged for both PCB designers and process engineers on the manufacturing floor.

PCB Design Training: More Critical Than Ever

09/05/2019 | Andy Shaughnessy, Design007 Magazine
I interviewed Gary Ferrari of FTG at the IPC High-Reliability Forum and Microvia Summit in Baltimore. Gary is a co-founder of the IPC Designers Council and a longtime advocate for PCB design and PCB designers. We discussed the crucial role that PCB designers play in the entire electronics development process, and how IPC and the Designers Council are helping to educate and inform the next generation of designers.

Whizz Systems on Competing in Silicon Valley

08/21/2019 | Barry Matties, I-Connect007
Whizz Systems is an EMS provider located in Silicon Valley that has managed to survive and thrive through many of the industry ups and downs of the past two decades. President Muhammad Irfan discusses the company's assembly and design services, as well as trends he’s seeing from the industry in the Valley. He also details how choosing the right type of customer has led Whizz to see sustained success in one of the most difficult and expensive areas for an assembly shop to survive.



Copyright © 2019 I-Connect007. All rights reserved.